Page 1 of 1
Help on cutting bar!
Posted: Fri Feb 17, 2006 9:59 pm
by dorza
Just after advise on cutting arb duluxe bar to suit 2 inch body lift on GQ
Where to cut for best result and strenghth. Just can't find thread on this.
As much detail as possible. Cheers Dorza
Posted: Wed Mar 01, 2006 5:06 pm
by xenith
remove bar measure from bolt hole on car to end of chassey then add 10 mm mark bull bar then cut bar. don"t foget to cut flat bar thickness off bull bar . use flat bar and weld on to bar (i used 25 mm thick but have seen 20 mm used )with exss hanging down same hight as body lift plus about 10 mm for good weld lift in to place and weld on to mount pices witch u will have bolted back onto car ( don't foget to disconnect battery on car befor welding )
