Outer Limits 4x4 Board

Hey All,

We'll its finally happened. Hanging around a bunch of Toyota Driving *&46wits has had its effect. I am now the proud owner of a set of Extreme Trekkers @ 35.5 inches.

They are on!!!

Installation Steps:

- Remove plastic inner guards
- Torsion bars wound up. Approx 1.5 inches.
- Cut front wheel arches out by approx 2 inches on back and front. Work off the top arc and aim for a 2 inch extension at each end.
- Cut out metal under headlights and beat back with mallett as far as possible.
- Bash back metal ridge on the back of the inner arch (near footwell) as far as possible (be gentle!)
- Cover cut metal with rust retardant and paint.
- Add set of flexy flares. (Front & back - about $120)
- Add rear spring packers @30mm. (Cruiser spring packers from Pro-comp @ $80)
- Put tyres on and drive around with a huge grin on your face

Job done. Pics below.

(Recommendation: Get a set of rock crawler gears before even dreaming of putting these tyres on. Otherwise you'll be a rocket sled downhill. We've taken it for a spin in low range with the 35's & crawlers and its ok.)

Go Paj

That looks evil daryus , looks tougher every time I see it Well done!!!!!!!!

Looks good Daryus
How does it drive onroad with 4.625's ??
Will you be requiring 5.29's

Thanks guys.

Power is fine, can still take off in second gear. But as expected, no torque. Don't expect to keep up with any cars with 308's in em.

Frank - The money is going in the bank each week specifically for that purpose.

Very cool Now stop being a show pony and DRIVE IT

Mate, just try and keep up

Ok, here are some pics of it in the daylight.

Daryus looks awesome man, daylight gives it justice, nice spare looks very tough mate, good to see, let us know how it drives

dean

Hey mate,
Have you wound the torsion bars all the way up until they hit the bump stops?
How does this effect ride?
Jason

so have you tested these bad boys out yet? how do they go?

sweeeet ............

whats the travel like???

they look awsome. are you going to mod the b/bar so it sits up higher after the bodylift?

Ok to answer the questions.

Tim - No, but I don't imagine the traction will be too different to the mongrels.

J-top - no problems with travel....due to guard love

NC - No, too bloody hard.


Car is currently sitting on the sidelines a bit disabled due to a broken hub. Also need to do the rear bearings.

Now, I have searched HIGH & LOW for a fricking Aisin manual hub and nobody (and I mean nobody) that I have gotten onto has them. I have called over 30 wreckers and recyclers from melbourne to Frankston to Ballarat.

If anyone knows where I can get a set, shout the fawk out

(Don't want another set of avm's).

i have bought two sets in the past from imlachs in clayton, always had them in .... just incase you havent tried there .... give em a call !

you could try oriental 4wd wreckers in adelaide. ph 08 83846055
cookie monster

Thread revival, how is this thing going? Still kicking?

Yeah its fine....what would go wrong?