Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
80 series steering HELP
Moderators: toaddog, Elmo, DUDELUX
80 series steering HELP
Has anyone rebuilt one of these and how the f#@k do you get the worm shaft ball bearings back in. They support the screwed shaft in the piston assy. The book says not to remove the wormshaft (thats probably why ) but I had to replace the seal in the valve body so there must be a way of getting the bearings back in. Otherwise I will have to get another one from the wreckers $$$$
I have done mine awhile ago, but haven´t taken pics of the job .
It took me almost all day to figure out how it works and then I was able to put it back together, basically you have to insert the shaft, then drop balls (1 by 1 / 1 after another) into it and spinning the shaft slowly which will allow the balls to find there way in, while you are doing so, don´t leave gaps between balls while spinning shaft, this will ensure you get all the balls back in, then fill up the U/bridge section with remaining balls and bolt it back on to the piston (or whatever it´s called).
It is a little more complicated than that, but mess around with it for a while until you understand how it works.
Ulises
It took me almost all day to figure out how it works and then I was able to put it back together, basically you have to insert the shaft, then drop balls (1 by 1 / 1 after another) into it and spinning the shaft slowly which will allow the balls to find there way in, while you are doing so, don´t leave gaps between balls while spinning shaft, this will ensure you get all the balls back in, then fill up the U/bridge section with remaining balls and bolt it back on to the piston (or whatever it´s called).
It is a little more complicated than that, but mess around with it for a while until you understand how it works.
Ulises
Ulises
www.OzSigns.com - 0400008422
www.OzSigns.com - 0400008422
box
for this section i used a small amount of grease to hold the balls in U/bridge section with remaining balls and bolt it back on to the piston (or whatever it´s called).
just put a small amount of grease to hold the balls but not to much i have done this to 3 steering boxes now so i have 3 boxes for spares and you can buy the seal kits from ebay quite cheep
Reece
just put a small amount of grease to hold the balls but not to much i have done this to 3 steering boxes now so i have 3 boxes for spares and you can buy the seal kits from ebay quite cheep
Reece
Who is online
Users browsing this forum: No registered users and 0 guests