Page 1 of 1
2.5 V6 GV engine into a 2.0 V6 Vit
Posted: Mon Feb 20, 2006 7:36 am
by cj
I've heard that someone has put a 2.5 V6 from a GV into a 2.0 V6 Vit and I think it may have been in Sydney but not sure. Can anyone point me in the right direction.
Posted: Mon Feb 20, 2006 4:07 pm
by Badooky
Yes it can be done, we have done one, goes nice
PM me
Posted: Mon Feb 20, 2006 5:36 pm
by oozuk
grahame at suzisport springwood did it to his 2L GV call him on (07) 3808 7637
Posted: Mon Feb 20, 2006 9:51 pm
by cj
Thanks.
Posted: Tue Feb 21, 2006 10:04 am
by cj
This is getting easier the more I learn
There are some pretty helpful people around too
The 2.5 block will bolt straight in, no fabbing of mounts required.
Posted: Wed Feb 22, 2006 4:54 am
by Huggy
why not go that little bit more stick a 2.7 in it they will do the same
Posted: Wed Feb 22, 2006 6:49 am
by cj
Apparently the 2.7 is a bit more involved. The 2.5 only needs a couple of minor things for it to be a bolt-in turnkey conversion. Simple is good. Plus the Engineer is good a 2.5 swap.
Posted: Wed Feb 22, 2006 6:28 pm
by Huggy
i have a 2.5 and slotted a 2.7 straight in without swapping computers or any wireing
Posted: Wed Feb 22, 2006 7:34 pm
by cj
Sounds good, somebody told me that the 2.7 was a bit more inolved where as the 2.5 was a straight swap but if that's the case then I'll have a look at it.
Posted: Sun Feb 26, 2006 6:50 pm
by danielt
Any chance of posting some more info on this?
I just went through a $3500 engine rebuild on my 2ltr GV because I was told that a 2.5 is a no go......
wish I knew.....