Outer Limits 4x4 Board

a couple of qns

1: If i were to buy a Boost guage how would i install it into a 12HT??? Is it possible??????

2? if i were to buy an Aftermarket Water Temp Guage but still keep the factory one operating as well how do i install the 2nd sender??? Is It possible?

3? when i get my 3" exhaust i am going to get a Pyro Guage for Exhaust Temp how hard are they to install???? Is it possible???

Cheers In advance

I can field the second one assuming it's the same as a 2h, (which i think it is).

on the exaust side of the block below the manifold there is a drain rooster. you can fit a sender into that

Boost gauge could be t'eed off the small hose running between your throttle body and factory Red an green light switchs on the inner drivers side guard
Pyro... Phsssff... that's why we pay the big bucks to the injection places....do an oil preesure gauge instead
Cheers
Scott

If you look at the dump pipe below the manifold you will see that mine has a boss fitted there, thats where you can put your pyro, mines on the way. The block drain is not a good place for the temperature gage as it should be near or in the head. Often when you drain the coolant or water from here it will be discolored or rusty or is that just mine.LOL. Anyway it has the water hose from the turbo stuck in there.cheers gazza.