Outer Limits 4x4 Board

Ok solinode is sorted. Now I need to know what wires I can hook up to a toggle switch so I don't have to run a ARB locka switch. There is 5 wires going to the switch and I think I only need two. I will be running a pilot lite on the dash too. I am using swich 1 in a ARB air locka wiring harnness if any body can help

1 goes to the compressor, 2 goes to the locker.

Any one?

the propper switches are only $12-$15 with dash and indication lights. Look alot neater

the propper switches are only $12-$15 with dash and indication lights. Look alot neater

If you dont wanna use a proper ARB switch (which I would if I were you).

On switch 1 you need to use the red and yellow wires on your toggle switch.
Blue is illumination and the two blacks are earths.

for the switch light just take the power for the light from the yellow wire (switched side of switch), run it through your chosen light and off to an earth point somewhere behind the dash.

hth.

They are too hard to flick in a comp. Im gunna put a huge toggle in instead. With a huge polit lamp I think it is yellow and red wire

Rhett wrote:They are too hard to flick in a comp. Im gunna put a huge toggle in instead. With a huge polit lamp I think it is yellow and red wire

Theres no think about it - I just told you thats what colours you need to use.

RTFM