Outer Limits 4x4 Board

was wondering what people have done to try to get better flex out of a mq i did a search but no real detail also what do you guys think the minimum amount of leaves you could run with in a sd33 mq ute with steel bar and ally tray


cheers

i usto cut all the load leafs down to sadle size thats the thick ones at the bottom mate on rear only front and back open up the leaf cloctors

Im running 4 in the front of my SD33T SWB. its nice, but i think too soft. Before it had 7 or 8 up front which i couldnt get to move if i swung off the front like a monkey. I guess it all depends on how good your springs are.


Cheers

I run 4 leaves up front, all shorter leaves removed and one above the main load leaf and fert the main load leaf there. I did the same to the rear, but had it down to 3 leaves. But that was to much so it was back to 4. Now i have one extra in the driverside due to sag, so its 4 pasenger side and 5 drivers side. It works well too.

mate runs 3 leaves each end in his shorty
flexes like a coily

it sagged a little in the first week or 2 but hasnt moved since and still has suprisingly good road manners for lifted with 35's and no sway bar

mate runs 3 leaves each end in his shorty
flexes like a coily

it sagged a little in the first week or 2 but hasnt moved since and still has suprisingly good road manners for lifted with 35's and no sway bar

I pulled 2 out of front and 3 out of the rear, flexed nice, but bent the rear ones first time! Now put all the leaves back in rear (7 passenger side, 8 driver side) and sort of fixed. 3 leaf parabolics work best If u can get em...

Are th e3 leaf parabolics the std 3 leaf set up. I have a full setup sitting in my trailerrusting away nicely. Might be tim eto clean them up