Outer Limits 4x4 Board

hey everyone

I have a 40 series and the tub has some rust an is rather rough in some places, just wanting to know how much it would cost??

cheers

A mate of mine here in Melbourne used to have his own sandblasting business, sold up a couple of years ago. At that stage, he was charging around $120/hour but would often quote private jobs a fair way below this mark. may not be of any use to you but may give you a starting point.

got frt n rear cab panels side steps n 2 doors done for 80 took the guy 20mins be sure to apply paint ASAP or surface rust will b there the next day. There is a guy (peter) in LINDORES cranes yard that does blastin his own bussiness tell him Col from blackwater sent u if that helps..

my brother did his chassis and body and it cost us around 500 to do them both. was quite expensive but worked pretty well.

skootin wrote:got frt n rear cab panels side steps n 2 doors done for 80 took the guy 20mins be sure to apply paint ASAP or surface rust will b there the next day. There is a guy (peter) in LINDORES cranes yard that does blastin his own bussiness tell him Col from blackwater sent u if that helps..

Hmm i forgot about the rust that could happen, because i need too take the body to the panel beaters aswell


Thanks for the prices that should be sweet now

i think it was 5 minutes and then the rust action would start its process on bare metal a panel beater once told me

Got a quote form Jim at All Blast in Brisbane about $100 for F + R Bar, roll bar and sliders.