Page 1 of 1

60 Series wheels HELP

Posted: Mon Mar 20, 2006 9:34 pm
by vSAHARAx
Hey there im looking at buying a set of rims for the cruiser. the wheels im looking at are

Allied Rhino 15"x10"
Offset: -44mm

Will these fit on my 89 Sahara? as i want to put 33"x12.5's on it and want a 10" wide Rim, is this the right offset?. will have it lifted 3" so i dont think height will be an issue.

Will the offset of -44mm be enough so the tyres dont stick out past the factory flares but yet i dont want it scrubbing on the springs.

I want these to fit!!!!!!!!

Cheers in advance!
Troy.

Posted: Tue Mar 21, 2006 7:20 pm
by vSAHARAx
haha Any body?

Posted: Tue Mar 21, 2006 7:59 pm
by Homer
I tried but difficult to measure when they are on the car
I have 15x8's with 33x12.5's on a HJ61 and they appear to measure approx -44mm offset and they clear the tie rod end on the inside by about 10mm (the weights touched on my FJ73) and the tyre sits flush with the outside of the car at the rear and stick out about 25mm at the front shhhh don't tell anyone
so considering your flares stick out about 50mm it should be OK
but try them on if you can..... to be sure to be sure
Cheers
Scott
Whoops reread it ....15x10's with -44mm could foul the tie rod end for sure if my measuremnt is accurate

Posted: Tue Mar 21, 2006 8:45 pm
by vSAHARAx
Cheers for that

as they say they aint big enough til they scrub, so ill see if they will let me try them on the car, i doubt it but its worth a try!

any more oppinions would be much appriciated

Troy.

Posted: Tue Mar 21, 2006 11:34 pm
by MQ080
15x8's with a -28 offset with a 12.5" tyre will sit flush with the body even without flares as the below picture shows.

15x10's with a -44 offset will almost certainly stick out past the guards even with the 12.5's.