Page 1 of 1
ARB steps to TJM bullbar 80 series
Posted: Fri Mar 24, 2006 1:04 pm
by Red Rover
They look like diffrent heights at the bullbar. As anyone had any success with this. Other wise i just buy a new bar, but a shame as i already have a high mount winch bar on it already
Posted: Fri Mar 24, 2006 1:42 pm
by Jeff80
Do you mean ARB steps/brushbars to mate up to a TJM bar?
If you are handy with a welder you could cut and shut it yourself. If not, any fabricator or welder will be able to do this mod. I have seen it done with a sleeve at the bullbar end and brush bar slipped over and bolted.
Jeff