Page 1 of 1
Flogged centre bearing problem.
Posted: Tue Sep 02, 2003 9:27 pm
by Kev80
My brother has a lifted 85 Hilux and always has trouble with the tailshaft centre bearing flogging out, last time he changed it, it lasted about 2 months. (Aftermarket not genuine)
Have heard of people using a single shaft, does this reduce the clearance by much ?
Any reason why Toyota didn't do this from factory ?
What do you guys do ?
Re: Flogged centre bearing problem.
Posted: Tue Sep 02, 2003 10:18 pm
by Pal
Kev80 wrote:My brother has a lifted 85 Hilux and always has trouble with the tailshaft centre bearing flogging out, last time he changed it, it lasted about 2 months. (Aftermarket not genuine)
Have heard of people using a single shaft, does this reduce the clearance by much ?
Any reason why Toyota didn't do this from factory ?
What do you guys do ?
It will reduce the clearance a little.
To compensate put the slip joint down at the diff end when you make it one piece.
Posted: Tue Sep 02, 2003 11:25 pm
by hypo
i went one peice coz my missus screwed my rear one of and at the time i need a new centre bearing and wanted a genuine job but a 320 or somthing i said fark that, i didnt want an aftermarket centre bearing as my mate had out in like 4 or so aftermarket ones in in a month so thats wot made my decision. and as already mentioned put the slip joint at the bottom 2 gain a bit of clearance back but it really aint that much 2 worry bout just get a good thick wall tube so that if u rest on it it wont kink easy