Page 1 of 1
Quarter Cuts
Posted: Tue Mar 28, 2006 11:45 pm
by mk swb
Can someone please inform me of a method of cutting quarters of my mk swb. once marked then what????? where to start please help??? and i looked at the bible but no info just some pics.
Cheers Rees
Posted: Wed Mar 29, 2006 6:09 am
by mickyd555
grinder.....................
Posted: Wed Mar 29, 2006 8:02 am
by Tiny
grinder with the thinnest disk you can get, if you want to fold back mark lower, if you want to weld a plate in mark where you want the final position to be
Posted: Wed Mar 29, 2006 2:52 pm
by mk swb
i have marked it where i want it to end up and do i just cut it off then weld a plate inside or do i get some bent up to fit inside then weld????? Whats the go whats everyone else do???? pics???
Posted: Wed Mar 29, 2006 5:42 pm
by Heathx4
Look in my member's thread for an example. Very common procedure.
Posted: Wed Mar 29, 2006 5:50 pm
by viperguy
i just cut where i thought looked good with the 4inch grinder..where i cut is probly marginaly higher then most guys. i cut the middle of the v-groove in the rear quater panel. then made a template and used a nylon cutting board as my plate material. sikaflexed them in place. took all of about 1 hr.