Outer Limits 4x4 Board

aircon belt snapped the other day i carnt seem to see how to loosen/tighten the tention on the belt or how to even move it to get the new one on

any one point me in the right directoin i might just be blined and not seen it but compard to the alternator and the powerstearing pump there is no tentioner that is the same for the aircon

any idears or bump in hte right direction would be nice


thanks

Is it diesel or petrol? On the TD42, there is a tentioner pulley which you need to loosen then adjust right off. To get it off, you need to remove PAS belt and Alt belts..

Nick

Some times they just wont budge. Just roll on the new belt and see how it fits. Might not even need any adjustment.

Cheers

yeh it is a TB42 i just carnt see were to ajust the tentioner

Mousie wrote:yeh it is a TB42 i just carnt see were to ajust the tentioner

There is a bolt (off about 14mm?) that you need to loosen aswell. It faces forward, cant remember exactly where.
Its not a tensioner but more of a lock.

Mousie wrote:tentioner

Its cause you spelt it wrong

look up from under the motor you will see a small pulley that sits below the aircon amd the pulley will be on a arm there is a bolt behined it 19mm if i remember undo it that is your adjuster take other belts of put new aircon on and adjust with pulling down on the arm thats on the small pulley when tight enough do up 19mm bolt then put rest of the belts on again while your at it get all new belts saves the trouble later on