Page 1 of 1
IPF 900 WIRING IDENT!
Posted: Tue Apr 04, 2006 2:17 pm
by familybus
i know theres the answer somewhere but im too lazy to look! theres two wires comin outa the lights one is black and the other is white with a black trace! black would obviously be earth correct? and also any diagrams with negative wiring to switch and high beam wiring stuff would be nice!
Posted: Wed Apr 05, 2006 5:48 pm
by familybus
please!
Posted: Wed Apr 05, 2006 6:18 pm
by 84ZOOKSTA
have a look here. there is info about wiring up lights that are negative switched.
http://www.outerlimits4x4.com/PHP_Modul ... highlight=
Posted: Wed Apr 05, 2006 7:01 pm
by pongo
My factory IPF fuse holder melted running only 100watt globes. I ditched it all and ran my own setup. There switches are very nice though
Food for thought.
Posted: Wed Apr 05, 2006 8:29 pm
by familybus
i had a switch melt on my saftey beacon then when i took out the switch and joined the two wires i melted the fuse holder and thats when i found out it was because i was runing too much power through switch then fuse holder hence with a relay it fixes that prob!
Posted: Thu Apr 06, 2006 9:52 pm
by pongo
i was using a complete ipf loom, relay and all. go figure.
Posted: Fri Apr 07, 2006 3:59 pm
by +dj_hansen+
It shouldnt matter with a globe dude... LED yes because they are diode... but in a globe it wont matter... pick a wire for active, and make sure the other is connected to chassis earth
Posted: Fri Apr 07, 2006 7:15 pm
by familybus
sweet thanks Dj ill do it this weekend ! onya bud!