Outer Limits 4x4 Board

Can i fit 32"x11.5"x15" BF A/T's onto 15X7 Rims??? dont care about legal issues at this stage, can it be done? Has anyone else ran/run them?

Cheers in advance
Troy

Yep, i run 32x11.50x15 BFG muds on my cruiser 15x7 original rims and haven't had a single problem for the last 3 years.....

Just don't lower the air in them more than you have to

Mate, if legal issues are irrelevant the only issue is the rim diameter.

15" = 15" = go for it.

Personally, I wouldn't put 11.5" tyre on 7" rims.

Scott

i know 15" is 15" i just wanted to know if i could fit them on 7" wide rims and if 'mad cruiser' says he is then i can too

11.5" on 15x7" isnt mandated as legal but safety wise 100% no issues.

The tyre width versus rim ratio is safe, and is exceeded in some approved OEM fittings.



I'd be a bit wary of letting them down below about 18psi though....... as I would with anything beyond a 1.5:1 ratio

theres a lot of guys (including myself) who run 12.5" tyres on 8" rims...so I cant see any problem with 11.5" tyres on 7" rims.

Yeah i run 32/11.5s on my standard 15/7 rims and have run them as low as about 15 psi with no dramas... and that giving them a flogging!

i run 285/75/16 (33x11.5) on 16x7 without any dramas.

the narrower the rim the better at low pressures as the sidewall is harder to push in from a rock etc and the carcass force outward is greater. 11.5 is narrow enough, should be fine. its only half an inch a side and 10'5 never look overly buldged out.

I ran 32 x 11.5 Silverstone muddies on 15 x 7s for ages, never had a problem.

Thanks fellas, exactly what i wanted to hear, as im buyin a set of 4 32'x11.5'x15 (80% tread) BFG All Terrains and 2 BFG Long Trails (which i may sell yet) cheap off a mate so i was hoping they'll fit.

Thanks again
Troy