Outer Limits 4x4 Board

Posted: **Sun Apr 16, 2006 9:08 am**

how do you cut off the rear bar on a gq so it looks good including the quater panels

Posted: **Sun Apr 16, 2006 11:52 am**

ive just done mine it is easy get a grinder and cut the buggers off and weld plates under, i will post some photos soon

Posted: **Sun Apr 16, 2006 12:23 pm**

Wouldn't you rather custom make a good looking and tough steel one?
Send me a PM if you need help and I'll make you one for a small fee

this is just an idea, the sky's the limit. its upto you if you chop the 1/4's or not

Posted: **Sun Apr 16, 2006 2:37 pm**

GQ Bear wrote:Wouldn't you rather custom make a good looking and tough steel one?
Send me a PM if you need help and I'll make you one for a small fee

this is just an idea, the sky's the limit. its upto you if you chop the 1/4's or not

is that your work? ...jerry and wheel carrier also?

Posted: **Sun Apr 16, 2006 7:10 pm**

GQ Bear wrote:Wouldn't you rather custom make a good looking and tough steel one?
Send me a PM if you need help and I'll make you one for a small fee

this is just an idea, the sky's the limit. its upto you if you chop the 1/4's or not

That bar looks familar

Posted: **Mon Apr 17, 2006 11:41 am**

I'm not being a smart ass

, but do you know what the GQ/Mav Bible is? It's at the top of the Nissan Forum page and contains a heap of useful info including the below link. Anyway hope it helps you and like I said not being a smart ass just some people don't notice it at the top of the forum.

http://www.outerlimits4x4.com/PHP_Modul ... hp?t=39167

Posted: **Mon Apr 17, 2006 12:15 pm**

bundyrum4x4 wrote:

That bar looks familar

i bet it does greg after it graced the back of your truck for so long

no, i did not make this particular bar, but i have made others similar.

this one and any other like it can be obtained from

Smithys Outback Gear
Cranbourne, Victoria
ph: 5995 4325