Page 1 of 1
Rangie Sills
Posted: Sun Apr 23, 2006 6:13 am
by Carl Coight
Hey guys, just wondering if door sill replacement has been discussed here yet?
I've already replaced 1 with 3mm RHS
and am half way through the second.
Before anyone says it , i've looked in serch!
Carl
Posted: Thu Apr 27, 2006 10:20 pm
by Loanrangie
I have replaced mine in a 2dr , had them made by a local steel merchant to my designs in gal sheet, made in 2 pieces - an inner flat section and outer L section. Cost was $15 for the pair !
Posted: Mon May 01, 2006 1:01 pm
by Carl Coight
Loanrangie wrote:I have replaced mine in a 2dr , had them made by a local steel merchant to my designs in gal sheet, made in 2 pieces - an inner flat section and outer L section. Cost was $15 for the pair !
Thats the go!
When i finally got around to pulling mine out i found they had been filled with news paper and bog!
Nearly done now so i will post up the pics tonight.
At least the doors will open and close properly.
Carl
Posted: Mon May 01, 2006 4:26 pm
by Loanrangie
Before i left school i did a short stint at a panel beaters o ver the xmas period and we had this XC falcon wagon come in that had been hit in the rear. When we went to strip it for repair, we found that the entire rear 1/4 panel was made of chicken wire and bog from the rear of the door to the tail light ! i filled my new sills with expanding foam once repaired.
Posted: Tue May 02, 2006 6:57 am
by Carl Coight
I can't get pics to work
It say the attachment is not allowed.