Outer Limits 4x4 Board

Hi
Anyone know if I can swap my 3am airflow meter for a 5am ? 3am is on 91 3.9 rangie and I have a 5am off a 3.9 disco 1994 ?

Anyone know any pin out info to check them . I have compaired the two and they seem the same , well close enough for me , but you never know .

Mine idles the same with it plugged in or not

Chris

Well put the meter on and when for a quick drive . Seems to go just the same .
From idle when you give it some gas it drops off a couple of hundred rpm then starts to pick up . Grrr .
Will leave it on for a while and see if the fuel consumption changes with the different air flow meter .

Any other ideas ? Temp sensor ok , tps seems ok .

Chris

check the resistance of the AFM it could be out of range - they are adjusted via the allen key bolt in the end of them - see the other thread which is just listed here as AFM

Tom

Rotazuk,
Are you the one who changed the TPS?
If not the TPS may be the problem.
Regards Philip A

Hi
No I have not changed the tps yet . When I had the mega squirt plugged in the tps seems to work ok for that , nice and smoth etc . I will see if I can scrounge one up to try thou . Would carry on with the megasquirt setup but one just had it idling and some bugger stole the laptop .


Cheers
Chris

Ok Have set up the pot to 174 , swap about 300 . I can't access the forum they discuss , not signed up etc so have not been able to check that . Will put my old one back in and see how it goes with that adjustment