Outer Limits 4x4 Board

just after the flywheel torgue settings on a g16a (16v inj)

and also pressure plate as well

thanks

i have changed my clutch a few times on my G16a carby vit motor.

i just did the bolts up bloody tight and as even as i could, with a lot of loc-tite. same with clutch as well as fly.

havent had any problems yet. and the reason why i do so much is because i give my vit too much when it doesnt have any reduction gearing, so the clutch just fries.

Cmon guys, have a seach around before you post up stuff like this. I found this page after looking in the bible. It says 14-20 ft/lb for the pressure plate bolts & 58ft/lb for the flywheel bolts.

thanks mate