Outer Limits 4x4 Board

I'm performing a SOA on a '94 Samurai, is there a need to make some modifications (cut, weld,..) to the crossmember that hold the tranny and t-case?
Will the front drive shaft hit it?

Thanks!

buger wrote:I'm performing a SOA on a '94 Samurai, is there a need to make some modifications (cut, weld,..) to the crossmember that hold the tranny and t-case?
Will the front drive shaft hit it?

Thanks!

if its real flexy it may hit it on droop but nothing to worry about

mine is touching the x-member just sitting there.... we're gonna chop it up and move it back and incorporate roc7oy's tcase ring into the new x-member.... the end result should look factory as.

if its only just touching you could take to it with a hammer? =)