Oil pressure warning light question 95 2.8 Ln106
Posted: Fri May 05, 2006 9:56 am
Hi chaps,
I have been lurking for some time, and have finally gotten a 95 ln106 dc 2.8d hilux. 235 k
The previous owner had not looked after it that well. It had peterol oil in it, and it was like soft honey.
I put some diesel oil in it, and ran about 40k, and dropped it that day, and then did 200k on the next, and am about to change it again, all in 14 days.
the question I have is this.
The oil light takes about 3-4 seconds to go out when I first start it, some times its been as long as 5 seconds for the light to go out. There is no noise of low oil pressure like its not got pressure at all when this happens.
I am wondering if oil is bleeding back out of the gallery that the oil press switch is feeding from. I have noticed that when I change the filter, oil drains out of the outer area of where the filter goes, *( yes I know some will leak out when removing the filter )*. I use a margarine container under it, and it catches the oil nicely, but it continues to drain for some time. Going by memory it looks like there is a ballvalve set up in there that is what is draining back.
Checked the oil yesterday, and its mostly clear, with only a fleck of black discolouration in it, so I might run it a little longer till it colours up.
Oil i have been using is the BP Vanellus 15 40.
There is no smoke out the back, apart from a little diesel black, as I got the injectors serviced, and have done a whole host of other stuff on it too.
Cheers
Trains
Save the Whales.........Collect the whole set !
I have been lurking for some time, and have finally gotten a 95 ln106 dc 2.8d hilux. 235 k
The previous owner had not looked after it that well. It had peterol oil in it, and it was like soft honey.
I put some diesel oil in it, and ran about 40k, and dropped it that day, and then did 200k on the next, and am about to change it again, all in 14 days.
the question I have is this.
The oil light takes about 3-4 seconds to go out when I first start it, some times its been as long as 5 seconds for the light to go out. There is no noise of low oil pressure like its not got pressure at all when this happens.
I am wondering if oil is bleeding back out of the gallery that the oil press switch is feeding from. I have noticed that when I change the filter, oil drains out of the outer area of where the filter goes, *( yes I know some will leak out when removing the filter )*. I use a margarine container under it, and it catches the oil nicely, but it continues to drain for some time. Going by memory it looks like there is a ballvalve set up in there that is what is draining back.
Checked the oil yesterday, and its mostly clear, with only a fleck of black discolouration in it, so I might run it a little longer till it colours up.
Oil i have been using is the BP Vanellus 15 40.
There is no smoke out the back, apart from a little diesel black, as I got the injectors serviced, and have done a whole host of other stuff on it too.
Cheers
Trains
Save the Whales.........Collect the whole set !