Outer Limits 4x4 Board

I loved it..

Put a chip in it & you will love it a lot more
I got 30% more power & 10% better fuel
& Thats at standard settings have 5 more to go
Email or pm me if u want more info
Dan

is that a transplant or is it in a cruiser
will the 1hd fte bolt up to a 80's manual no wories?

known 2 wrote:is that a transplant or is it in a cruiser
will the 1hd fte bolt up to a 80's manual no wories?

Thats a 100 series I think..
Ehsan

Yes, picture is of a "cold spec" RHD HDJ100.

Cold spec because it has the belt driven viscous coolant heater.

If thats a hunjy, clean your engine bay....have some pride before you take a photo. I have seen HQs with cleaner engine bays and they are 35years old

known 2 wrote:is that a transplant or is it in a cruiser
will the 1hd fte bolt up to a 80's manual no wories?

but willl that engine bolt into a 80's 5 speed no worries?

sniper wrote:If thats a hunjy, clean your engine bay....have some pride before you take a photo. I have seen HQs with cleaner engine bays and they are 35years old

Lets see yours

oh o, been caught out here

which one my 80 cruiser or my HJ tonner

Anyone want to give a quote to rebuild the injection pump. I have been told $4,000.00 is that correct or am I being led up the creek.? great motor when working ok , for sure. cheers.

sniper wrote: oh o, been caught out here

which one my 80 cruiser or my HJ tonner

the 80 of course

i`ll get back to you shortly.............................and no of coarse im not going to clean it first

sniper wrote:If thats a hunjy, clean your engine bay....have some pride before you take a photo. I have seen HQs with cleaner engine bays and they are 35years old

.. If I had a vehicle like that, It would be cleaner.. .. For someone else's vehicle... I dont care.. I love taking photos.. ..

Anyone want to give a quote to rebuild the injection pump. I have been told $4,000.00 is that correct or am I being led up the creek.? great motor when working ok , for sure. cheers.

$4000 for what? Just rebuilding the pump? How much is a new one for over there?
Ehsan

you want a new pump morgauge your house over here. Toyota parts are worth more then diamonds.

And i was only takin the piss about the engine bay ...........or was i .........nah i was ..........

sniper wrote:you want a new pump morgauge your house over here. Toyota parts are worth more then diamonds.

And i was only takin the piss about the engine bay ...........or was i .........nah i was ..........

Course ya were takin the piss !!!! "Shortly"

well it was $ 960 to rebuild my 1hz injection pump so i think u are being led up shit creek and could someone answer my above question

known 2 wrote:well it was $ 960 to rebuild my 1hz injection pump so i think u are being led up shit creek and could someone answer my above question

I just checked what I was told as I thought I may have misunderstood what was said in a group with other people talking at the same time.
Local injection place quoted $6,000.00 for a new pump, also seems $4,000.00 for a rebuild is plauseable depending on whats damaged of course.
He also said there are only two people rebuilding these pumps in Oz so they must be sent out of town or back to Japan. He also advised that fuel that is not pure and would not damage an old inline pump will cause problems in one of these if it gets in past the filter when I asked about drum fuel.Can you get a price where you got your pump done???

I would suggest that "Cooma Diesel" is one of those two places that could rebuild the EFI pump. Give them a ring (at their Fyshwick address - freecall 1800 637 322), they have always been very helpful and should be able to fill you in on what is going on.

yes the efi pump may be more expensive but as i said my 1hz mechanicle injection fuel pump cost $960 and that was to replace all the seals in the pump cos it was pissing out fuel.

ask toyota what its worth might be cheaper to buy a new one.

Its for around US$1000 here in Pakistan.. Very good condition I am told.
Ehsan