Page 1 of 1
Offset trunion bearings.
Posted: Tue Sep 16, 2003 11:04 am
by Wendle
Where do I get them and how much should I expect to pay
Posted: Tue Sep 16, 2003 11:37 am
by planb
im pretty sure 4way sell these.
Simon should be able to help
9672 8899
$280 odd
half degree, 1 degree and 1.5 degree
Posted: Tue Sep 16, 2003 4:33 pm
by Wendle
Found them locally for $160 per side, anything up to 2.5deg.
Thanks Rhys, I'll ring up 4way and see if that price is per side or for both. BTW, is your truck a goer at the moment??
Posted: Tue Sep 16, 2003 4:40 pm
by planb
yerp
building a track bar as i snapped a shaft the other week on my first real outing,
should be done by sunday,
Posted: Wed Sep 17, 2003 10:37 am
by bj on roids
hey wendle can you tell me how these work?
Posted: Wed Sep 17, 2003 10:57 am
by Wendle
there is a couple different types, I believe. The ones I am getting replace the bearing and cap with a setup that uses a slightly smaller OD bearing, so there is room for an offset shim/cup doodad to fit into the machined reccess in the axle trunion.
Posted: Wed Sep 17, 2003 2:05 pm
by bj on roids
thanks for that, i had these guys going for a while
Posted: Wed Sep 17, 2003 2:09 pm
by Wendle
bj on roids wrote:thanks for that, i had these guys going for a while
Camber correction makes baby jesus cry!
Posted: Wed Sep 17, 2003 10:30 pm
by dumbdunce
correcting camber or castor?
Posted: Thu Sep 18, 2003 8:25 am
by Wendle
dumbdunce wrote:correcting camber or castor?
correcting camber caused by a homebrew hybrid axle
I have adjustable links for castor
