Outer Limits 4x4 Board

hi all, just a quick one;

i am looking to make up some custom add-ons for my rhino racks (tradesman) and also some custom racks in the rear of the jack, i would like to use the same square section tube that they use with the captive nut relief in them, so i can keep uniformity with the add-on eyelets and brackets etc.

Does anyone know if this is available as raw stock, or is it an "exclusive extrusion"

cheers all, Brad.

Unistrut is the manufacture.
call them.
I use the stuff at work all the time but in steel.
Burnsy

Yeh, I use the unistrut for work too, but again only is steel, noy in aluminium. Try builders supplies or electrical supplies wholesalers.

I'm sure you could order it if you visit a rhino stockist, there is a much larger dealer catalogue of parts available than what’s listed on the rhino website

It is the same profile as unistrut because unistrut make it
http://www.tycoflowcontrol.com.au/unist ... ts/suparax
You can get unistrut in galv steel and aluminium.
http://www.tycoflowcontrol.com.au/unist ... al_framing

awesome, thanks guys i will check them out.

Geez problem now is i have seen its available in stainless

oh the descisions

I got 2 lengths of stainless steel unistrut for the back of my tray, cost me, sorry, cost my subbie, about $500 for the two lengths!!

the joys of working with sub-contractors!

oops