Page 1 of 1
Body lift
Posted: Tue May 30, 2006 7:41 pm
by eddy 76
sorry to go over it again guys but I am doing a body lift on my nk lwb this weekend and for the blocks will be using aluminium bar. Have done a couple on hiluxes already and used 50mm dia bar but from what Ihave read in the tech section most paj owners seem to be using 65mm bar is this right. would also like to know what others have done where recovery hook comes through rear bar.
cheers eddy
Posted: Tue May 30, 2006 7:54 pm
by -Scott-
My body lift was done with 65mm diameter blocks, and I wouldn't use less.
The rear bar was cut either side of the recovery point, and it's difficult to spot the gap.
I'd post a pic if they worked...
Scott
Posted: Tue May 30, 2006 8:51 pm
by eddy 76
thanks scott is yours engineered and does your insurance company know about it as i would like to get it all approved. I spoke to an engineer about it and he reckons there was no need to have it approved.
cheers eddy
Posted: Wed May 31, 2006 8:35 am
by -Scott-
Mine was approved in Qld, but I haven't transferred registration yet.
Yes, I told my insurance company - no problems.
Scott
Posted: Wed May 31, 2006 8:07 pm
by eddy 76
Thanks scott, I spoke to insurance company today and no probs at all also got 65mm dia bar so just a matter of finding time to do it now probably next weekend.
Posted: Sun Jun 04, 2006 8:33 pm
by eddy 76
does anybody know of another good body lift page as one in tech thread no longer works for a gen2 paj
cheers eddy