Outer Limits 4x4 Board

Does anyone have the drawing of the spindle from jacmac for the toy conversion. Did a search and its gone. Mines not fitting up and just want to check all the measurments, it seems to be about 3mm out.
Cheers Damien

This one?

Yep thats the one, well i measured up my spindle and it measures up the same, but when i bolt it up, it bolts up hard to the cv and the swivel is hard to move (no movement in the axle).
When i push the spindle up against the cv, it sits a couple of mm away from where it bolts up, it like the bush is to thick or the axle spline is to short or the cv is to long, its only by a couple of mm's.
Any ideas?
Thanks Damien

6.5 rangie wrote:Yep thats the one, well i measured up my spindle and it measures up the same, but when i bolt it up, it bolts up hard to the cv and the swivel is hard to move (no movement in the axle).
When i push the spindle up against the cv, it sits a couple of mm away from where it bolts up, it like the bush is to thick or the axle spline is to short or the cv is to long, its only by a couple of mm's.
Any ideas?
Thanks Damien

The axles are slightly to long. This is common with Jeffs axles. He makes the 30 spline axles to suit his 30 spline locker. You need to take a skim off the end of the axles. We usually do this in a drop saw and have experainced no problems after doing this.

Which is the best end to take a bit off?
Rears fit good though
Thanks

6.5 rangie wrote:Which is the best end to take a bit off?
Rears fit good though
Thanks

Yep rears are allways good. Take a little off the inside end(diff Centre end).

Thanks tony will give ot a go

Damien

Trimmed a couple of mm of the end and they fit great now.
Thanks again