Page 1 of 1

Transfer case Question

Posted: Thu Jun 08, 2006 1:00 pm
by Aerenandmel
Is there a way to reduce my low range, but leave my high range as is. I have a toyota 5sp box that will just sit on 110km and the speedo is calabrated so I dont wanna wreck this. But it still crawls to quik in low range.

Posted: Tue Jun 13, 2006 10:45 am
by Swamp Donkey
i'v seen your zook and i WOULD NOT DRIVE THAT THING 110!!!

Re: Transfer case Question

Posted: Tue Jun 13, 2006 11:04 am
by Gutless
Aerenandmel wrote:Is there a way to reduce my low range, but leave my high range as is. I have a toyota 5sp box that will just sit on 110km and the speedo is calabrated so I dont wanna wreck this. But it still crawls to quik in low range.
not really.

Series 1 rockhoppers or 4.16 calminis will still reduce high range to the equivelant of a standard 1L transfer case ( around 12%). this is prolly the most tame reduction gear set you can get.

twin transfers with a 1:1 high in the second case would work tho... :roll:

Posted: Tue Jun 13, 2006 6:04 pm
by JrZook
I run a early 1L transfer and yes its roughly 12% lower in highrange. With 235/75's i run around 3700rpm at a 'real' 100kph compared to around 3500rpm at 100kph with the std tcase. (1.3+5thgear)

Posted: Tue Jun 13, 2006 6:46 pm
by Aerenandmel
yeah, the thing is that I dont want to reduce high range, only low range.

Posted: Wed Jun 14, 2006 12:26 pm
by Fourdogs
if you are mechanically inclined you could try and creat something out of a vitara transfercase that could then sit between the existing gearbox and case. 1:1 high and 1.8 reduction on top the the existing ratios.

Posted: Wed Jun 14, 2006 1:27 pm
by Swamp Donkey
if you have a cool $1500us to waste there is a Rock Block on Trail tough that will help you out. [img]2to11_small.jpg[/img]