Outer Limits 4x4 Board

does anyone have a diagram of the central locking in a nh pajero i have centrl locking but it is not remote i am looking at inatalling an after market keyless and add to factory system.or please email mick on
rdp83@aapt.net.au. cheers everyone have a good long weekend

They are easy to do & you shouldn't need a wiring diagram. What I have done with other vehicles without remote locking is just added it as a piggyback.

I can't check with mine cos it's factory remote.

if you press down on the drivers lock do all the doors lock?
Yes?
And then push down on the passenger lock and see if they lock.
No?

If no then it means there is most likely no motor in the drivers door to lock the door,

SO you then need to buy another motor to go with the kit. Easy to rig up, just connect it to the 'wire' that runs between lock and button on the door trim to pull it down when it locks.

Then mount the alarm & control pack, it'll have an 'out' which gives power to the door motor to lock the drivers door and then the original system takes over and locks the rest of the doors.

Hope that makes sence, it does to me but it may not!

What i did is baught a $200 imobiliser which incorporated in that is an unlock and lock function.
All i did is find which wires are the unlock and lock at the central locking module which is located near the RH kick panel under the dash (black box from memory). When you lock the drivers door there should be a wire that powers up in the lume to the module and vice versa for unlocking.
Just wire in the wires marked "lock" and "unlock" on the immobiliser module into the wires on the central locking module and then it operates off the remote, as well as having an immobiliser!

Hope this helps
Gabe

thanks guys i will look at it tomorrow all the adivce is great and thankyou