Page 1 of 1
1hz turbo oil supply
Posted: Mon Jun 12, 2006 10:36 pm
by shanegtr
Is the oil supply for aftermarket turbo's taken from the oil pressure sender? Dosent seem to be a lot of room there as its right near the starter. If not wheres it taken from? What tread is the tapped hole?
Posted: Tue Jun 13, 2006 10:06 am
by dow50r
Yep, its taken from there...a tee piece is required, i think the thread is metric, but close to 1/8 bspt
Andrew
Posted: Tue Jun 13, 2006 5:36 pm
by dumbdunce
dow50r wrote:Yep, its taken from there...a tee piece is required, i think the thread is metric, but close to 1/8 bspt
Andrew
I think it's an NPT thread but you can jam a brass BSP fitting in there. Enzed or Pirtek will sell you all the relevant bits.
there is plenty of room to get a T piece in there.