Outer Limits 4x4 Board

How much preasure do you put in second air bead locks. do you leave that preasure in all the time or only when you plan to air down

I leave 30 psi in the tubes..

25-28 in the tyres.The ones i have says to have the tube 2psi higher

DR Frankenstine wrote:How much preasure do you put in second air bead locks. do you leave that preasure in all the time or only when you plan to air down

There should be pressure in them all the time, otherwise they can slip and tear of their valves

40-45 psi seems to be the recommended pressures to leave in the tubes (per Procomp Narre Warren) regardless of the pressure you run in the tyre. The idea is to keep the bead of the tyre pressed hard against the rim This stops both the tyre slipping and the tube slipping. The idea is to stop the tyre being pushed off the rim, so having it only 2 psi above what you have in the tyres anyway is pointless (possibly why they get a bad rap from some ppl)

I've run 40/8 psi with no dramas....

40 to 45 all the time

i was just goin to say 45 to 50 psi is now the recomended pressure 4 them.

40-50 it is then. Thanks fellas
just bought some 37x13.5x15" baja claws on rock crawler rims with internal beadlocks all brand new but no instructions on the beadlocks

I run mine on about 40psi also. I always run them about 10psi higher than my tyre presure.

Cheers Mick.