Page 1 of 1
advance adapter & marlin instructions
Posted: Thu Jun 15, 2006 7:46 pm
by 4sum4
Advance adapters instructions are pretty shiat,Can you use the same principles as
Marlin`s and it mentions in Advance adaprters that you need to cut part of the shift rod off is this necessary?
Posted: Thu Jun 15, 2006 8:51 pm
by Frankenyota
Did dual case install with two top shift cases and didn't have to cut shift rods, best to see how far the rod comes out then check it against the other case.
However i did have to grind the input shaft so it would fit up to the adapter. Found marlins instructions heaps better.
cheers Matt
Posted: Thu Jun 15, 2006 9:42 pm
by spazbot
Yeah i used marlins for my install and its all the same basically
Also found if you got a 12mm drill run it through the adapter in the hole for the front shift rod, as both of the castings ive worked with were very tight and it helps shifting a lil bit.
I also run the 2nd ball from the front cast behind the spring for the front shift to give it some extra locking force as i found i likeed to jump out of gear into netural on down hill runs.
Posted: Fri Jun 16, 2006 5:49 pm
by 4sum4
how much extra oil do i need
Posted: Sat Jun 17, 2006 3:55 pm
by 4sum4
so I`m left with a speed-o bushing WTF is that for
Posted: Sat Jun 17, 2006 4:16 pm
by spazbot
that the tapered looking bolt thing with a hole in the middle ?
if so mines still in my box and ive never found a use for it
Posted: Sat Jun 17, 2006 5:21 pm
by Frankenyota
That's what i would like to know?