Page 1 of 1
knock sensor... where? and how?
Posted: Fri Jun 16, 2006 8:19 pm
by Vulcanised
as the title says..... i am going to look at a new memcal and knock sensor soon.... how hard is it to fit the knock sensor? and where the hell do they go?
No i didn't use the search function
Posted: Fri Jun 16, 2006 9:38 pm
by Bartso
the knock sensor goes into the side of the block pretty easy and there should be an allowance in your loom for the knock sensor to plug into
i think?
knock sensor
Posted: Fri Jun 16, 2006 11:00 pm
by tuf045
http://cgi.ebay.com.au/Holden-HSV-185kw ... dZViewItem
hey there roedao maybe these are worth looking at because they come with a wiring loom and all other stuff needed.
Posted: Sat Jun 17, 2006 12:07 am
by HotFourOk
Re: knock sensor... where? and how?
Posted: Sat Jun 17, 2006 12:33 am
by GQPatrol V8
RoeDao wrote:as the title says..... i am going to look at a new memcal and knock sensor soon.... how hard is it to fit the knock sensor? and where the hell do they go?
No i didn't use the search function
RoeDao,
Get yourself a knock sensor from a V6 from the wreckers , they are the same as the V8 one. The sensor screws in into the side of the block (Just about pan rail). There will be a drain plug in the spot at the moment.
As for the wiring - It is a single wire that you run back to the computer inside the car and connect it to pin B11 of the computer.
Shane
Re: knock sensor
Posted: Sat Jun 17, 2006 8:58 am
by Vulcanised
thats the one i am considering getting
the same guy also sells the sensor without the chip.... watching another chip on there out of a HSV going pretty cheap