Outer Limits 4x4 Board

both these Qs ive search but cant find anything really about them

Q1. i am getting a set off dogbox rear windows to replace the sliding ones.
In the bible it says how to get the sliders out and in but has anyone
fitted the one piece windows back in,if so was the go or is it a job for
the pros.

Q2. i have been given two 30mm spaces to hopefully fit the front of the
gq as it does not sit level and i want to try and get the front up abit.
if i fit them will it have much of an effect on shock length and travel
or is it that minimal its not worth worrying about. This is going to be
temporary until i can make up my mind on what type of bigger lift to
go with plus saving to go to U.S.A at the end of the year so most coin
is going towards that not the truck

Cheers

not sure about q1, but i put 30mm spacers all round on top of 4" lifted springs and haven't had a problem

Spacers :Make sure the spacers are front ones if you put them there, they are different from front to back
Windows :There is also a thread in the GQ bible explaining how to get them back in, or wait for bogged to respond....

currentlyoffline wrote: Windows :There is also a thread in the GQ bible explaining how to get them back in, or wait for bogged to respond....

currentlyoffline wrote:Spacers :Make sure the spacers are front ones if you put them there, they are different from front to back
Windows :There is also a thread in the GQ bible explaining how to get them back in, or wait for bogged to respond....

yeah read that but its for putting the slider ones back in i would like to know if its the same for the one piece windows