Page 1 of 1
anyone know any sites...
Posted: Mon Sep 29, 2003 7:37 pm
by robbie
that give step by step instructions in rebuilding a petrol motor?
it should pretty much be the same concept for a petrol motor I guess.. looking to rebuild a 22R soon for my bundy, want to give it a crack myself
Posted: Mon Sep 29, 2003 7:44 pm
by Area54
Seriously, you might be able to do a course - you get to do the rebuild during the course - with an experienced teacher to help you through the stages, and also without you having to buy exotic tools.
Posted: Mon Sep 29, 2003 7:45 pm
by robbie
you dont need heaps of tools to do a rebuild do ya? I mean, send the block away for the machine work etc..
will need a torque wrench, the tool they used to compress the rings around the piston, what else? no idea here..
Posted: Mon Sep 29, 2003 7:56 pm
by Area54
There are a lot of accurate measurements as well (bearings, oil clearances etc), depends how much time you have to run the parts around and have them measured by the shops. You can always benefit from someone elses experience - got any motor mates? Also depends on what sort of quality you want - just a re-reing or total, long term reliable full rebuild?
Posted: Mon Sep 29, 2003 7:59 pm
by robbie
yer, but I want to do it myself so I can learn to do it and do it when ever I want to in future

Posted: Mon Sep 29, 2003 8:02 pm
by Area54
I can understand that, but it's good to learn from an experienced person (there are a lot of mistakes you can make - you dont want an unreliable motor in a fourby)
Posted: Mon Sep 29, 2003 8:03 pm
by robbie
true that

Posted: Mon Sep 29, 2003 8:04 pm
by bazzle
Ypu can enroll in an after hours engine rebuilbing class at your local Tech college.
Then the notes youll get will have pratically experience att.
Bazzle
Posted: Mon Sep 29, 2003 10:51 pm
by bogged
robbie wrote:you dont need heaps of tools to do a rebuild do ya? ..
if your serious here about the tools (

), leave it to someone else.. Theres lots of tools needed, and then some special ones, and lots of bandaids for knuckles.
Buy yourself a set of workshop manuals, not cheap, but well worth it. they are usually step by step on what you need, and show tools, torque settings, what to take off in what order, and put back, etc...
www.pitstop.net.au is a good place to try
Usually a shifter, multi grips, and a rubber hammer are enough for an engine rebuild

Posted: Mon Sep 29, 2003 11:16 pm
by robbie
heh good call bogged, I was under the impression a torque wrench was the most expensive tool in rebuilding / freshening up a motor.. (apart from workshop machines)