Outer Limits 4x4 Board

ok sorted the heat mark thing but after further inspection there is a small chip on the cradle that holds the bearing in place were the bearing sits this is each spot on the cradle that there is a bearing

god i hope someone understands that

cheers

The parts of a CV are:

Bell and stub (main body of the CV and integral stub axle)
Star (part inside with splines)
Balls
Race (part that holds the balls in place)

Do you mean that you have a chip in the race of your CV? Is it really a chip or is it a crack?

If it is a crack - sounds like it is on the way out - if it is a chip, how could it have happened and is it somewhere it will matter strength-wise?

it has an identical chip in every ( the valley part) of the race

muduppig wrote:it has an identical chip in every ( the valley part) of the race

Any pics - you sure it is a chip? or was it made that way???

i know what you mean, i had one the same. i put it back in and it was very clicky. it held up to a locked hiding until i snapped the axle part of the cv. i ran it for prob 6 months, was just annoying and embarasing everytime i pulled on lock.