sd33t dump valve
Posted: Sat Jul 15, 2006 7:12 am
What is the factory dump valve set to? i.e what p.s.i. will it dump?
Page 1 of 1
Posted: Sat Jul 15, 2006 7:16 am
mine was 10psi..
Posted: Sat Jul 15, 2006 11:52 pm
mine was 5psi
dump
Posted: Sun Jul 16, 2006 6:56 pm
Mine would blow off at 11-12 lb until I pulled it out and welded it shut. You could also just stick a plug in the hole.
Posted: Sun Jul 16, 2006 7:53 pm
i purchased a plug from my local ENZED fitting store.
cost me $1.50 with soem thread tape
running 12.5psi no problems
cost me $1.50 with soem thread tape
running 12.5psi no problems
Posted: Mon Jul 17, 2006 4:49 pm
Hang on - so you fixed your excessive fuel consumption problems then???84mksd33t wrote:i purchased a plug from my local ENZED fitting store.
cost me $1.50 with soem thread tape
running 12.5psi no problems
Mk
Posted: Mon Jul 17, 2006 5:08 pm
dont get him started.Patroldude wrote:Hang on - so you fixed your excessive fuel consumption problems then???84mksd33t wrote:i purchased a plug from my local ENZED fitting store.
cost me $1.50 with soem thread tape
running 12.5psi no problems
Mk
But seriously have you!!!