Page 1 of 1
question about MQ models and flywheels
Posted: Mon Jul 17, 2006 11:20 am
by Brendan-s
About to do the 5psd swap into my 82 diesel shorty, and we're planning on a drive-in, drive-out swap-over. Shafts are all lined up (am planning on doing the swap on a weekend, then measuring the required lengths and getting them made up on Monday), new clutch kit's sitting on my desk, getting a new rear main seal this weekend, etc.
The gearbox is an 85 petrol 5spd. I want to find a flywheel to have machined up and ready to go straight in to save dicking around. Are the flywheels the same on all models or model-specific? Does anyone have one they want to sell me?
Posted: Tue Jul 18, 2006 7:05 am
by David_S
According to my Jan 86 parts book the Part Nos for flywheels are 12312-C6000 for the P40; 12310-C6800, -C6802 & C8700 FOR THE SD33 and different again for the L28 which also has a different one for the automatic.
When I put a 5 speed ex diesel into my P40 I had to shorten the main shaft and change the pilot bush from 3/4" to 5/8" ID. The OD was the same at 15/16". The clutch splines on the shaft matched up with my original clutch fine.
Posted: Tue Jul 18, 2006 7:44 am
by V8Patrol
I think I have a couple of diesel ones spare in the shed ( have to check first tho )
Posted: Tue Jul 18, 2006 1:23 pm
by Brendan-s
thanks kindly for the replies. V8, you have a pm.
Posted: Tue Jul 18, 2006 6:11 pm
by rickstrap
ive got a set of drive shafts and fly wheel for 85 sd33 two suit 5 spead
Posted: Tue Jul 18, 2006 8:08 pm
by MQSWBUTE
i got a flywheel for sd33 (3.3 litre diesel nissan) sittin in my shed condition in unknown i took it off the motor that i dropped into mine becuase i knew the one i had was in good nick welcome to come get it
bit of surface rust where the clutch plate sits prob suit a machining
came off a 5 speed 1984 model swb patrol mq
Posted: Wed Jul 19, 2006 1:53 pm
by Brendan-s
awesome mate... how much you want for it? i need it asap, i'll have some money for it on Friday...
edit: sorry, scratch that mate, i found one...
Posted: Wed Jul 19, 2006 3:33 pm
by MQSWBUTE
4130warrior wrote:awesome mate... how much you want for it? i need it asap, i'll have some money for it on Friday...
edit: sorry, scratch that mate, i found one...
if you were talkin to me i'll give it away for $40
btw i have sent u a pm with my number ur welcome to pick it up today or tonight tomorrow upto u
Posted: Wed Jul 19, 2006 3:37 pm
by Brendan-s
yeah i was. sorry mate, i found one in sydney (where im at). thanks heaps anyway.
Posted: Wed Jul 19, 2006 3:41 pm
by MQSWBUTE
aw no probs i was not sure where u where from its a long trip for a flywheel good luck with it mate