Page 1 of 1

Front Axle

Posted: Sun Oct 05, 2003 9:00 pm
by bubs
Reassembling the front axle, the swivel balls have surface rust on them.

I was going to just use some fine sand paper and clean them up.

Is this bad, it shouldn't mark the surface to much using fine sand paper :?:

Posted: Sun Oct 05, 2003 9:02 pm
by RUFF
Wet and Dry should be fine. Do it wet it gives a smoother finish. The seals that run on the swivel are not a real good finish to start with so you should get no real probs.

Posted: Sun Oct 05, 2003 9:06 pm
by bubs
thanks tony :)