Page 1 of 1

Hilux 1 piece driveshaft ?'s

Posted: Mon Oct 06, 2003 1:20 pm
by Area54
Ok boneyarders (or auto parts recyclers to be politically correct), looking for some tech on one piece rear driveshafts (to replace the two piece/centre bearing config) on LN65 hilux. Single case in my rig, what other (standard) shafts are available from the wreckers? I've seen some 1st gen shafts - but it has a smaller flange mount with M8 bolts - not sure if they use the same size uni (if so, no problem). Any others that will fit?

Posted: Mon Oct 06, 2003 6:25 pm
by RUFF
Nothing fits it has to be custom made to length. Also there is no stock length one that will work with the dual Case set up.

Posted: Mon Oct 06, 2003 6:44 pm
by Lil Menace
I was going to say My 4 runner is one piece but i guess that wont fit.
Sorry :cry:

Posted: Mon Oct 06, 2003 9:52 pm
by Kev80
We ended up having a 3" diameter single shaft made for my brothers Hilux as we kept flogging out the centre bearing, all good so far.

Cost about $300 from memory.

Posted: Tue Oct 07, 2003 11:38 am
by MKPatrolGuy
RUFF wrote:Nothing fits it has to be custom made to length. Also there is no stock length one that will work with the dual Case set up.


Ruff it says he has a Single case.

Posted: Tue Oct 07, 2003 6:55 pm
by RUFF
Yes it does and your point being???

Posted: Tue Oct 07, 2003 8:25 pm
by MKPatrolGuy
RUFF wrote:Yes it does and your point being???


Sorry, I misread your post. I though you were saying Area54 had twin cases so nothing will fit :oops: