Outer Limits 4x4 Board

hi all i have a 1.6L mpi motor going in to my sierra. i have the fitting kit to bolt up to the gear box and i have the custom mounts so i dont have to cut and weld. what cluch do i need to use, the 1.6 or the 1.3 and how hard is it to wire up

u use a 1.3 flywheel and clutch assembly,u will ned an auto elecy to wire it up prolly cost $600

$600 , i paid 200

bazooked wrote:$600 , i paid 200

Bazooked, was that mates rates or retail?

I am reasonable comfortable wiring mine but good to know some prices.

Thanks

Nic

$200 thats a bargin,what did he do?wire a set of spot lights in

how hard is it to wire in if i have both wire dirgrams

depends how technical you want to get,

i only needed three wires to wire up my mpi jimny motor, but i kept the full loom and dont have dash warning lights. all i did was found what colour the wires i needed were(acc, ign, etc) and then hooked them up from existing wires in the standard loom.
My Loom was uncut when it was removed from the car which was a bonus.

if u have a cut loom it can be easy-hard. depends how it was cut.
I wired mine from scratch, read very hard, pay someone else to do it unless u have an interest in auto elec.