Page 1 of 1
warn high mount question
Posted: Sat Oct 11, 2003 7:58 pm
by mav
hi, i just pulled apart my warn high mount brake assembly and the friction plates are shagged and there were no ball bearings in there, does anyone know the size of the ball bearings ??? and what are the clutch plates worth.
Posted: Sat Oct 11, 2003 10:21 pm
by 60serius
The brake overhall kit is about $140 from ARB
brake kit
Posted: Wed Oct 15, 2003 12:45 pm
by mav
Posted: Thu Oct 16, 2003 1:03 am
by duncan
pulled my high mount down again today as it wont free spool the only thing that looked out of place was that the free ball bearings seemed to have jammed up dose anyone no if you can get the balls in a cage so that they have to stay in postion
Posted: Thu Oct 16, 2003 5:18 pm
by mav
duncan wrote:pulled my high mount down again today as it wont free spool the only thing that looked out of place was that the free ball bearings seemed to have jammed up dose anyone no if you can get the balls in a cage so that they have to stay in postion
try the pirate 4x4 site the have a good article on rebuilding them the use grease to hold all the balls in place.
Posted: Thu Oct 16, 2003 6:40 pm
by ToNkA
