Outer Limits 4x4 Board

Just ordered a new clutch for the Sierra.
Am going to fit it myself which i was going to in the first place.
Out of curiosity I got them to give me a price on installation...

$640 fawkin dollars

Looks like ill be doing it myself

Should I also be replacing throwout bearing or anything else while I have it apart?

Cheers Paul..

you should get the throw out bearing in the clutch kit depending on what you ordered

mistaboz wrote:Just ordered a new clutch for the Sierra.
Am going to fit it myself which i was going to in the first place.
Out of curiosity I got them to give me a price on installation...

$640 fawkin dollars

Looks like ill be doing it myself

talk to Ontrack in East Keilor, will do it for way better than that mate.

Just did mine. Kit cost $176 + $50 for engine mount. Pulled motor and box out, took about two and a half hours over four days.

Just get a mate to help you lift the whole engine out, probably easier then doing it with the engine in. Yes you will need a throwout bearing, check the cable condition as well while you're there.

Got it all back together. Everything is running ok.

Had a look under the car today and there appears to be a little bit of oil near the thin plate that bolts to the gearbox (near the flywheel).
Any ideas?

Cheers

rear main seal . cheers ron ps mine does same

Yer think it is.
Funny thing is it wasn't leaking previously. Coincedence?
Not that it's much oil, just that I know its there.

don't worry it will only get worse

get the little bearing that the gearbox shaft goes into as well

gear oil or motor oil

Yep, replaced it RB zook. Cheers