Page 1 of 1
Sierra body lift
Posted: Fri Aug 18, 2006 9:24 pm
by Sean
g'day all,
im planning on putting a body lift in my Sierra. would polyurethane be the best material to use? and would i need to use rubber washers where the body and chassis touch the block?
cheers,
Sean
*EDIT* spelling
Posted: Fri Aug 18, 2006 10:24 pm
by jtraf
unless you drill through the body poly block wont work. 6 main mounting points are attached to the body and will either need special lift blocks made or you can do the dodgy and just use 4mm 50x50 rhs blocks.......
Posted: Sat Aug 19, 2006 8:33 am
by just cruizin'
Contact Gutless off this forum, he makes a lift kit that does not require you to cut the body studs etc. I think he uses ally blocks. Very easy to install with this method and fully reversable. Good dollars from memory.
Polyurethane is OK, this is what I used, just place them between the body and the rubber mounts. The rubbers around the chassis should go back in the same order. If you use Gutless ( Peter's) kit you have to drill the cup wahers at the very bottom out to 16mm I think.
Posted: Sat Aug 19, 2006 10:13 am
by Sean
thanx for the reply fellas. it wont be happening for a while just checking my options, etc.
cheers,
Sean
Posted: Sat Aug 19, 2006 9:13 pm
by Nev
ive got one of the reversible suzisport steel block kits that I had on my car for a few months if your interested. Comes with everything you need including steering shaft spacer etc. $150