Outer Limits 4x4 Board

before i remove my headers has anyone got any tips on removing rusty studs, other than dont break em. their coming off a 4.2 gq. i thought of soaking the studs in oil over night then cracking em. what else can make it easier

Theory on this board seems to be use a spray like penatrene or inox but it that doesn't help use a bit of heat. A good going over with the wire brush if you can too before and after you use the above mehtods.

I am a huge fan of both Inox and Penatrene, but for rust it is hard to go past this stuff,
http://www.wurth.com.au/mechanical.asp
it seems to disolve the rust.
Peter.

I wire brush the rust off the exposed threads then run the engine for a bit to heat them up. It can be fun getting your hand in there without burning yourself though

Damo wrote:I wire brush the rust off the exposed threads then run the engine for a bit to heat them up. It can be fun getting your hand in there without burning yourself though

]
\usually when you involve a mate to give you a hand