Page 1 of 1
Black Widow fitment from 80 series to GU
Posted: Fri Sep 08, 2006 10:20 pm
by Neetas
Hi all - does anyone know if the side contour panels of the BW are the same width from the 80 series to GU Patrol (side by side drawers). The BW1000 is specified for both cars with the draw dimensions the same. Doesn't mention about the width of the side contour panels. So will it fit without the angle grinder?? I'm aware the fitting kits are different, which I assume is what bolts it to the floor. Any info would be appreciated.
Thanks
Mike
Posted: Sat Sep 09, 2006 12:09 am
by jimsaq
dunno myself, but you should give black widow a call, or ARB southside (coopers plains, brisbane) - I called them when I was enquiring about refitting my black widow stuff from a prado to my GU and they were both really helpful
Posted: Sat Sep 09, 2006 7:13 am
by djd2
The actual center draw system will fit straight in but the wing kit is different.Straight from a guy that owns a ARB store.
Posted: Sat Sep 09, 2006 7:53 pm
by RogTJ
I've just purchased the kit to change my BW system from 100 -> GU, different plywood wings (6), and differendt supports for wings plus different bolt down system. Also recycling the 1/2 cargo-barrier so new bracket for this. I was supprised that all this only cost around $300. Being fitted on Tuesday, I have re-carpeted the whole lot today in preparation.