Page 1 of 1
Hilux with 3.8 connvertions
Posted: Sun Sep 10, 2006 2:55 pm
by Dungerlux
dose anyone know how to put a tacho in to suit a 3.8 holden moter
Posted: Sun Sep 10, 2006 6:26 pm
by ratboy
on the loom right hand gaurd there is a wire taped up taco will run of that wire
Posted: Sun Sep 10, 2006 9:05 pm
by madmont
I put a tacho on mine a few years back. I took a signal directly from under one of the coils on the coil pack. You will need a 2 cylinder tacho to read this signal. A tacho to read a 2 cylinder signal is a BIT DIFFICULT to find . So I bought a tacho which was switchable between 4 6 & 8 cylinders ( these are readily available). The switch on the back of the tacho simply switched between 3 different resistors to select the number of cylinders. I carefully looked at the 3 resistors and calculated the resistance needed for 2 cylinders and soldered the new one in in place of one of the others and it worked. Easy as
Posted: Mon Sep 11, 2006 1:02 pm
by Scott
I bought a black box from Marks adapters and use the factory tacho. I don't think it cost too much and saved me thinking too much. The signal comes off one of the wires at the coil pack.
Posted: Mon Sep 11, 2006 6:43 pm
by rover1
if you undo the black tape around the v6 wiring loom where it goes in to the cabin, on the the engine bay side near the firewall there is a brown wire that is just loose and the black tape goes over it. it is a tacho wire also. it easy to find.
you can take your hilux dash cluster to an auto elec and they change change it and make it work for you, last one i had done was 37 bucks.