Outer Limits 4x4 Board

Posted: **Mon Sep 18, 2006 11:16 pm**

Is there anyone in OZ that makes up axle-shafts to custom lengths/spline counts? Has any-one had any made over here, or is importing from U.S.A my only option?

Nick

Posted: **Mon Sep 18, 2006 11:27 pm**

Woop wrote:Is there anyone in OZ that makes up axle-shafts to custom lengths/spline counts? Has any-one had any made over here, or is importing from U.S.A my only option?

Nick

You can subbi the work out if you can sweet talk. I looked into doing this a while ago - worked out around $150-$200 a shaft (full floater). As long as the gear cutting mob has the right sized tool it should be cheapish for the hobbing. The steel and heat treating is nothing major. CASH is your friend.

Posted: **Tue Sep 19, 2006 10:04 am**

Yeh Glenn Dobbin of Dobbin Engineering will. Try him on 02 9609 4446

Posted: **Tue Sep 19, 2006 11:09 am**

GEELONG DIFFERENTIAL SERVICES.

MAKE THEM.

Posted: **Tue Sep 19, 2006 11:11 am**

http://www.geelongdiffs.com.au/

MICHAEL.

Posted: **Tue Sep 19, 2006 12:20 pm**

Is there anyone in Brissy that will do a cut & respline?

Outer Limits 4x4 Board

Custom axle shafts

Custom axle shafts

Re: Custom axle shafts