Page 1 of 1
WHats the wheel stud thread size on a paj?
Posted: Mon Oct 02, 2006 6:49 pm
by pongo
I have some Factory mags i bought off here ages ago, and they have a square hole for the nuts instead of a taper.
I was hoping to find out if the paj nuts will fit on my Nissan, might save a few $$ and headaches chasing up some nuts.
Thanks
P.S. Or will tapered nuts holem on no probs. Its going to be pretty much an on road toorak tractor
Posted: Mon Oct 02, 2006 7:13 pm
by hudson44
You'll have to get square section nuts and washers. Don't think they're that expensive. I wouldn't use your old tapered nuts as they wont seat properly!
Posted: Tue Oct 03, 2006 10:57 pm
by pongo
apparently there 12x 1.5 mm . same as toyota but not nissan.
thanks anywayz guys
Posted: Tue Oct 03, 2006 11:42 pm
by -Scott-
FWIW, I had some Nissan (Skyline) alloys converted to tapered seat inserts so I could run tapered wheel nuts.
I don't remember the price, but it was cheaper than buying the required wheel nuts. Four or five years later, and they're still going strong.
Posted: Thu Oct 05, 2006 9:38 pm
by Yonnee
pongo wrote:apparently there 12x 1.5 mm . same as toyota but not nissan.
thanks anywayz guys
You are correct. Paj's are 12mm x 1.5 same as Toyota. Nissan's 12mm x 1.25.
I can't tell you of a simple fix 'cause I don't know of any Nissans running that style of wheel nut. Be careful also of the diameter of the shank of the wheel nuts as this helps locate the wheel rim along with the centre boss of the hub.
Hope this helps,
Yonnee.
Posted: Thu Oct 05, 2006 11:24 pm
by j-top paj
Yonnee wrote:pongo wrote:apparently there 12x 1.5 mm . same as toyota but not nissan.
thanks anywayz guys
You are correct. Paj's are 12mm x 1.5 same as Toyota. Nissan's 12mm x 1.25.
I can't tell you of a simple fix 'cause I don't know of any Nissans running that style of wheel nut. Be careful also of the diameter of the shank of the wheel nuts as this helps locate the wheel rim along with the centre boss of the hub.
Hope this helps,
Yonnee.
are you sure dude? now im
im sure i had the nuts from my paj on my pootrol and vice versa
Posted: Fri Oct 06, 2006 5:06 pm
by J Top
No way do nissan and Paj wheelnuts interchange
J Top
Posted: Fri Oct 06, 2006 5:58 pm
by zooksport
Nissan are 12 x 1.25, same as Suzuki.
Mag nuts should cost around 2.50 ea, with washer
.
.
Posted: Thu Oct 12, 2006 12:12 pm
by pongo
yeah, I might just resell the rims on ebay, unless some one here wants them for what i paid
Cheers