Page 1 of 1

3inch...can i get away with it?

Posted: Fri Oct 13, 2006 2:05 pm
by Xplode
gotta a 93 vit...putting it up 3 inches and sliding 31 under it on 15x8 rms with big negative offset...with a bit of trimming will it rub like bugger...no serious offroading til i get the BL!

cheers!

Re: 3inch...can i get away with it?

Posted: Fri Oct 13, 2006 10:52 pm
by SiKiD_01
Xplode wrote:gotta a 93 vit...putting it up 3 inches and sliding 31 under it on 15x8 rms with big negative offset...with a bit of trimming will it rub like bugger...no serious offroading til i get the BL!

cheers!
the name vit or vitara does not seem to go too well with: 31", 15x8, big neg offset etc.


you can fit 31"s on easy, you will lose a lot of turning ability. which mean you can only drive straight ahead. this is because of the front guards and the floor well/firewall of sorts.

my mate had a 3" BL, but couldn't run 31"s on properly. he now has 3" sus and the 3" BL and runs the 31"s no probs.

the problem being, the rear of the front guards does not allow enough room for anythbing bigger than a 235. but, with a little trimming of the outer guard, you should be ok on flat roads. with a 30, you will rub on the foot well when steering and one front tyre compressing up.

the problem is the neg offset wheel. anything more neg than stock rims greatly increases the scrub radious of the front tyres. so if you have big neg off set wheels, you will have a huge scrub radious, and you will find the outside edge of the tyres scrubbing on the rear of the guards and the front bumper maybe.

i had to bash the poo out of my foot wells to fit and clear 33"s.

IMHO, i would aim to fit 31"s on a stock vitara before lifting it at all. there is still the same amount of work needed. all that means is, you can run 31"s on a stock vit, with no lift, and then when you come around or can afford any lift, you will have no problems at all. so if you can clear 31"s with a stock vit, imagine if you had a 3+3 combo and how much more room there is. this is how i did mine.

Posted: Fri Oct 13, 2006 11:05 pm
by SiKiD_01
i just dug up some old pic of my vit.


this is my vit 10 mins after i put some 31" with 15x8's on my vit. see how close the rear of the front tyre is to the guard. this is where you need to chop.
Image


this is a bog stock vit running only 235's.
Image


this was the end of the day after i did a 3" BL. i was still running 235's
Image


this is after i did the cutting and trimming and bashing. i was able to run 31"s easily with NO suspension or body lift at all.
Image
Image


this is 10mins after i fitted new 31"s. this is with a 3" body lift only.
Image

fgjhgf

Posted: Tue Oct 17, 2006 3:29 pm
by big vitara
i run a LWB vitara with 3" body lift and 3" suspention lift combo, there was a little rubbing on the front bumper but a small section cut out fixed that.

Posted: Tue Oct 17, 2006 5:30 pm
by cj
I put some 7.50-16's (31" -32") on with a 3" suspension lift and no trimming.

Posted: Tue Oct 17, 2006 7:05 pm
by SiKiD_01
cj wrote:I put some 7.50-16's (31" -32") on with a 3" suspension lift and no trimming.
narrow tyre narrow rim combo will work.

sierra wide track rim off set in a 7" rim would probably work well. NT and vit rims have too much pos offset.