Page 1 of 1
Warn Hi-mount to scorpion winch bar
Posted: Fri Oct 13, 2006 8:07 pm
by def90
i know i should ask in the pommy forums, but has anyone here heard or seen if its possible to fit a warn hi mount to a scorpion tube comp winch bar?? on a defender.
Posted: Sat Oct 14, 2006 12:49 am
by Michele
You can,
but must specify "winch bumper for 8274" in your order
winch bar
Posted: Sat Oct 14, 2006 8:29 am
by def90
cheers michelle, mate already got the bar, think i'll just have to do some measurements.
Posted: Sat Oct 14, 2006 7:50 pm
by Aquarangie
If it takes Warn, it should have the same mounting holes. I have an ARB winch bar that had a hi-Mount fitted to it prior to my purchase and i have a M8000 low-mount and fitted without no issues at all
Trav
warn
Posted: Sun Oct 15, 2006 1:28 pm
by def90
cheers trav but i think the issues lies in if the himount will foul at the top - into the a frame part of the bar[/i]
Posted: Mon Oct 16, 2006 8:36 pm
by jbell
def90 i've got a scorpian bar on my county.
it was a prick just to get the low mount in.
good luck if you want aircon. i took my condenser out.
got a hi mount too, but lots of work to get it in, so
i'm thinking of swapping the hi mount for a 12000lb
low mount as my 9000lb only just does the job, already
cooked a couple of solenides. good luck
cheers Jeff
Posted: Mon Oct 16, 2006 9:51 pm
by Maggot4x4
jbell wrote:def90 i've got a scorpian bar on my county.
it was a prick just to get the low mount in.
good luck if you want aircon. i took my condenser out.
got a hi mount too, but lots of work to get it in, so
i'm thinking of swapping the hi mount for a 12000lb
low mount as my 9000lb only just does the job, already
cooked a couple of solenides. good luck
cheers Jeff
I have a 12000 low mount i will swap for a highmount